Connecting the Cables
All ProView connectors are located on the rear panel. Connect the following:
Input Cables
■
If you are using DVB-S/S2, connect the satellite cable to the RF IN connector. If you are
using ASI, connect the ASI cables to the connectors marked ASI IN.
Management LAN Cable
■
Connect the management LAN cable to the Management port.
Video Output
■
Connect an output destination to one of the output connectors on the output interface.
Video Monitor
■
Connect a video monitor, for local monitoring of the output, to either the CV MON or the
HDMI port.
Switching On
Before switching the ProView on, make sure that all cables are correctly connected. Ensure
that the unit is connected to the main power supply and correctly grounded.
❖ Switch the unit on with the rear power switch.
Once the boot process is completed (after 2-3 minutes) the Status OK message displays
on the front panel LCD.
© 2013 Harmonic Inc.
Status OK
Figure 2: Front panel startup display
Harmonic Inc.
4300 North First St.
San Jose, CA 95134, U.S.A.
T +1 408 542 2500
F +1 408 490 6770
www.harmonicinc.com
© Copyright September 201 3 Harmonic Inc. All rights reserved.
Manual Part No. MAN-PVR-7K-IG-3.2
No Service Selected
No Service Selected
6
ProView 7000 r.3.2, Rev. A