Advertisement
Attach back of case to door jamb or wall. Snap
front of push button on.
When attaching push button using double sided
tape, make sure the surface of the door jamb or
wall is clean.
Mount
Chime Unit
with Arrow
Pointing Up
Note: Most installations will not require you to change any code set-
tings on your chime and push button.
The push button and chime communicate by using a code that can be changed
by changing dip switch positions or removing and/or adding jumpers on both
the push button and chime. The code is factory set; however, there are 128
selectable codes that allow you to expand your system and prevent outside
interference. Other wireless products may cause interference and the sys-
tem may not function properly. Follow the instructions below for setting a
new code.
1. Open the cases and locate the jumpers on the push button and the dip
switches on the chime (see Figure 6).
2. The push button has eight different jumper locations and the chime has
seven dip switches. The jumper positions 1 through 7 are used for setting
the code.
3. To change the code, add and/or remove jumpers and change dip switch
positions as needed. It is recommended to only change one code position
at a time and then check to see if system is functioning properly. Note:
Code positions 1 through 7 must be exactly the same for both the push
button and chime for this system to function.
Note: Unit will come factory set with jumpers in locations 5, 6, and 7 on the
push button and dip switch locations 5, 6, and 7 in the "ON" position (see
Figure 6).
ON
1 2 3 4 5 6 7
Figure 5
Code and Tune Settings
Code Settings
Attach chime unit using two
Holes for
screws and wall anchors pro-
Wall
vided. Insert screws into screw
Mounting
holes as shown in Figure 5.
Note: Using arrow inside
chime unit as a guide, mount
chime with arrow pointing up
(see Figure 5). Snap cover
onto chime base.
-2-
Figure 4
598-1149-00
Advertisement
