Table of Contents
Advertisement
Adjusting the sound
You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the button,
the adjustable items change as
follows:
BAS
(bass)
VOL
LOUD
(volume)
(loudness)
Indication
To do:
BAS
Adjust the bass.
TRE
Adjust the treble.
FAD*
Adjust the front
and rear speaker
balance.
BAL
Adjust the left
and right speaker
balance.
LOUD
Boost low and high
frequencies to
produce a well-
balanced sound
at low volume
level.
VOL
Adjust the volume.
* If you are using a two-speaker system, set the fader
level to "00."
SOUND ADJUSTMENTS
TRE
FAD
(treble)
(fader)
BAL
(balance)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
50 (max.)
2
Adjust the level.
To increase the level.
Note:
Normally, the control dial works as the volume
control. So you do not have to select "VOL" to adjust
the volume level.
Using the sound control memory
You can select and store a preset sound
adjustment suitable for each playback source
(Advanced SCM).
Selecting and storing the sound modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM, tape
and external components.
• If you do not want to store the sound mode
separately for each playback source, but want
to use the same sound mode for all the sources,
see "To cancel Advanced SCM – SCM LINK" on
page 21.
Select the sound mode you want.
Each time you press the button, the
sound mode changes as follows:
BEAT
SOFT
To decrease the level.
POP
SCM OFF
17
Advertisement
Table of Contents
