Table of Contents
Advertisement
Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex.: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the band (FM1 – 3, AM) you
want to store stations into (in this
example, FM1).
Each time you press the
button, the FM band
changes as follows:
FM1
FM2
2
Tune into a station of 88.3 MHz.
Press ¢
into stations of higher
frequencies.
Press 4
into stations of lower
frequencies.
3
Press and hold the number button
(in this example, 1) for more than 2
seconds.
7
"P 1" flashes for a few seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
Notes:
• A previously preset station is erased when a new station
• Preset stations are erased when the power supply to
Tuning into a preset station
You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 6.
FM3
AM
1
to tune
2
to tune
is stored in the same preset number.
the memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.
Select the band (FM1 – 3, AM).
FM1
FM2
Select the number (1 – 6) for the preset
station you want.
7
8
9
FM3
AM
10
11
12
7
Advertisement
Table of Contents
