English
5 - CONTROLS DESCRIPTION
Important
The dispensing keys of the machine are programmed with
pre-set values.
5.1
Main controls
Main switch (Fig. 5)
Located in the rear side of the machine, centre-left.
When in the "I" position, the machine is on (electrical
functions on).
When in the "O" position, the machine is off (electrical
functions off).
Control panel (Fig. 6)
It consists of 4 keys with different functions according to the
machine mode (standard running or setting mode).
SELECT PRODUCT
READY FOR USE
8
Fig. 5
Fig. 6
Dispensing mode
In this normal running mode, the following operations can
be performed by pressing the keys as indicated in figure 6:
Keys
,
,
Dispensing programmed beverages
=
espresso coffe
=
light coffee
=
hot water
Setting mode
In this service mode, the following operations can be per-
formed by pressing the keys as indicated in figure 6:
E
ENT key - "Espresso coffee"
Confirm modified parameters.
Allows you to go to the lower programming level
C
ESC key
Return to higher settings level without saving new pa-
rameters.
UP key - "Coffee"
Scroll Menu and increase the displayed value for reset-
ting.
DOWN key - "Hot water"
Scroll Menu and decrease the displayed value for reset-
ting.
Dispensing LEDs
Dispensing LEDs are green LEDs located inside the three
selection keys. During beverage dispensing, only the LED
corresponding to the selected beverage remains on. After
beverage dispensing, all three LEDs turn back on.
Display
It consists of 2 15-character lines and it displays mes-
sages about operations under way or programmed and
about the machine status.