Yaesu VX-3E Operating Manual page 89

The speed at which the DTMF digits are sent can be changed. Two speed levels are avail-
able: Low (10 digits per second) and High (20 digits per second: default). To toggle be-
tween Low and High speed, use the following procedure:
1. Press and hold the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 29: DT SPD.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key to enable adjustment of this Set Mode
Item.
4. Rotate the DIAL knob to select the desired speed ("50MS": High
speed or "100 MS": Low speed).
5. Press the PTT switch to save the new setting and exit to normal operation.
You can also set a longer delay between the time your transmitter is keyed and the first
DTMF digit is sent. To set the delay time, use the following procedure:
1. Press and hold the [ TXPO ] key for one second to enter the Set mode.
2. Rotate the DIAL knob to select Set Mode Item 27: DT DLY.
Note: Do not forget to pull the DIAL knob to rotate the DIAL
knob.
3. Press the [ TXPO ] key to enable adjustment of this Set Mode
Item.
4. Rotate the DIAL knob to select the desired delay (50/250/450/
750/1000MS).
5. Press the PTT switch to save the new setting and exit to normal operation.
VX-3R/E O
PERATING
DTMF A
UTODIALER
M
ANUAL
DTMF O
PERATION
87