Vfo Scanning - Yaesu VX-3E Operating Manual

S
CANNING
This mode allows you to scan on the VFO mode.
1. Select the VFO mode by pressing the [ V/M ] key, if necessary.
2. Press and hold in the [ BAND ] key for one second, and rotate the
DIAL knob while holding in the [ BAND ] key to select the band-
width for the VFO scanner. Available selections are ±1 MHz,
±2 MHz, ±5 MHz, BAND, ALL, and PMS-X.
±1 MHz, ±2 MHz, ±5 MHz: The scanner will sweep frequencies within the selected
BAND:
ALL:
PMS-X:
Note: Do not forget to pull the DIAL knob to rotate the DIAL knob.
3. Release the [ BAND ] key to start scanning.
4. When the scanner encounters a signal strong enough to open the squelch, the scanner
will halt temporarily; the decimal point of the frequency display will blink during this
"Pause" condition.
5. The scanner will then resume according to the Scan-Resume mode selected in the
previous section.
6. To cancel scanning, press the PTT switch or [ V/M ] key.
1) When you start scanning, the VX-3R/E will be changing frequency in the
upward direction. If you want to change direction of the scan while it is un-
derway, rotate the DIAL knob one click in the opposite direction (in this case,
one click counter-clockwise). You'll see the scanner turn around and change frequency
downward!
2) You may change the scanner's method of operation so the VFO frequency will jump
to the low band edge of the next band when the VFO frequency reaches the high edge of
the current band (or vice versa). See page 121 regarding Set Mode Item 90: VFO MD.
56
VFO S
CANNING
bandwidth.
The scanner will sweep frequencies only on the cur-
rent band.
The scanner will sweep all frequencies between 1.8
MHz and 999.99 MHz (except the FM Broadcast Band:
76 - 107 MHz).
The scanner will sweep frequencies within the cur-
rently-selected PMS frequency pair. See page 61 for
details.
VX-3R/E O
PERATING
M
ANUAL