Quick Setup Steps - Centurion G-SPEAK Installation Manual

Quick Setup Steps

These abbreviated instructions are for the experienced
installer who needs a checklist to get a standard installation
up and running in the minimum of time.
Detailed installation features and functions are referred to
later in this manual.
Mount the Calling Module according to the
instructions given in the Installation section.
Connect the GSM Controller to the Calling Module
according to the wiring diagram in the Wiring
section.
Insert a network and RICA-registered SIM card (with
some airtime loaded onto it) into the SIM card holder
on the GSM Controller as shown on page 18.
Connect a 10V - 30V DC power supply to the GSM
Controller according to the instructions in the Wiring
section. The backlight on the Calling Module will light
up, and the GSM Controller will begin network
registration. Once registered on the network, the
Calling Module will emit three short beeps. Signal
strength will be indicated on the signal strength LEDs
next to the antenna connector as shown under
Section 7.
Program the unit. See Section 10.
Call a Voice Phone and gauge voice quality and
volume. It is important that the Calling Module and
phone being called are separated by at least 20
meters to prevent feedback.
Determine if any interference is noticeable during a
call. Adjust the antenna placement to resolve any
interference issues. The antenna should not be
placed close to the Calling Module.