Gsm Controller Mounting - Centurion G-SPEAK Installation Manual

GSM Controller Mounting

The GSM Controller will typically be housed inside the enclosure of the device it is to
control, for instance a gate motor. However, it can be mounted onto a wall or other
structure by following the instructions below:
1. Insert screwdriver into slot on the
GSM Controller and twist.
2. Remove the cover and unclip and remove
the circuit board from the retaining clips.
3. Mark position of the unit against the
mounting surface.
4. Using a 5mm masonry bit, drill a hole
into mounting surface.
5. Mount the unit using suitable fasteners.
GSM
Controller
Slot
Screwdriver
Cover
Fastener
page 15
FIGURE 18.
Circuit
board
FIGURE 19.
Mounting surface
Mounting
hole
FIGURE 20.