Adjusting The Calling Module Volume - Centurion G-SPEAK Installation Manual

There will be a delay of up to ten seconds while the call connects, after which a ringtone
will be heard from the Calling Module. Once answered by the Called Party, the call will
end after either:
1. The call duration has expired (the default call duration is 30 seconds).
2. The call is terminated by pressing either of the Call Buttons on the Calling Module.
3. The call is terminated by the Called Party.
4. The hang time (the time for which the call remains connected before disconnecting
after a DTMF tone) expires. The default hang time is 15 seconds.
Three beeps from the Calling Module indicate that the call has ended.
While the call is in progress, the Called Party can activate the one output on the
G-SPEAK Classic, or any of the four outputs on the G-SPEAK Classic+ by pressing 1,
2, 3 or 4 on their phone keypad. This DTMF event will trigger the hang timer, and the call
will automatically terminate after the hang time has expired, regardless of the call
duration up to that point.
Three configurable call parameters can be customised by the user (see List of
Commands):
1. Call duration – The maximum call length (Range 10 seconds - 60 seconds, default is
30 seconds).
2. Ring time – The time for which the Called Phone will ring before the Calling Module
disconnects (G-SPEAK Classic), or tries the second number
(G-SPEAK Classic+) (range 10 seconds – 60 seconds, default 15 seconds).
3. Hang time – The time for which the call remains connected after a DTMF event
(range 2 seconds - 30 seconds, default is 15 seconds).

Adjusting the Calling Module volume

The Calling Module volume can be changed (between 10% and 80%) by following these
steps:
1. Press both Call Buttons simultaneously.
2. Wait for two beeps.
3. Use Call Button 1 to increase the volume (10% per press), or Call Button 2 to
decrease the volume (10% per press). On each press, a beep will be heard with the
new volume.
4. When done, press both buttons again simultaneously (or wait 30 seconds).
5. The Calling Module will beep twice, and an SMS will be sent to the first Voice Phone
number assigned to Button 1, indicating that the volume has been changed.
page 23