Required Tools And Equipment; Mounting Instructions; Calling Module Mounting - Centurion G-SPEAK Installation Manual

5. Required Tools and Equipment


Screwdriver – 3.5mm flat
 Side cutter
 Drill bits – 5mm masonry; 6mm drill bit
 Silicone sealant
 Fasteners and rawl plugs
 Six metres of n6 core communication cable

6. Mounting Instructions

Important Considerations
All users calling or sending an SMS to the Module need to ensure that their Caller Line

Identification Presentation (CLIP) is activated on their phone to ensure that the
Module recognises the user's learned-in phone number
If a contract SIM card is being used in the Module itself, CLIP must also be enabled on

that SIM card. This can be done by first inserting the SIM card into a mobile phone
and enabling CLIP
Ensure that the SIM card in the GSM Module does not have Call Forwarding enabled

The SIM card in the GSM Module must have the PIN (Personal Identification Number)

code disabled

Calling Module Mounting

Wall mounting recommendations
Position the Calling Module on

wall adjacent to entrance gate or
door
Mount at a height that allows for

comfortably speaking into the
microphone
A typical recommended height is

shown in Figure 5
Gooseneck mounting recommendations
Ensure that the Calling Module

does not protrude too far into
the driveway
The Calling Module must not be

set too far back and must be
easily accessed from a vehicle
The height should allow for

comfortably speaking into the
microphone
Calling
Module
page 10
FIGURE 5.
Calling
Module
FIGURE 6.