D-Link DCS-2000 Manual page 50

Check here to enable proxy.
Check here to enable filter.
Enter IP address to add
If you enable proxy server and enable IP restriction, the listed IP
addresses will not use the proxy.
Connecting to the DCS-2000
Once you connect to the DCS-2000, you can drag and drop a camera to the
video area.
In the channel area, if you do not set up the camera, the color of the camera
number will be gray. Once you set up the camera, the color of the camera
number will turn into blue. You can drag and drop the camera to the video
area, and apply other features if you have the the privileges.
There is a unique light signal above each camera's number. It indicates the
status of the camera:
Off – Camera is not connected.
Green –
Red – The red light indicates the camera is both connected and in
recording mode.
Blink – If motion detection is enabled and there an alert occurred, the
light will blink.
Click OK
The green light means the camera is connected.
50
Set the proxy
Add an IP address
Delete an IP address