Safety; Work Rules; Tools And Equipment Needed; Mechanical Installation - AEC ACM Series Operation And Installation Manual

Safety

2-1

Work Rules

2-2

Tools and Equipment Needed

2-3

Mechanical Installation

ACM Series Dehumidifying Dryers
Install, operate, and maintain this equipment according to
applicable work and safety codes for your location. This includes
OSHA, CE, NEC, CSA, SPI, and many other local, national, and
international regulations. Obey these specific work rules:
Read and follow the instructions in this manual before
installing, operating, or maintaining any equipment.
Additional copies are available from AEC, Inc.
Only qualified persons should work on, or with, this
equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this
equipment.
You'll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not
already in place)
• Mounting bolts with nuts and washers
Dryers may be mounted on the machine, a stand, or a mezzanine.
Be sure it is securely attached and additional bracing is used if
necessary. The sections on the following pages explain general
installation rules.
Read manual thoroughly before installing dryer.
Use approved safety straps or chains to lift the
dryer at the marked lifting points.
2
Page 15