Site Requirements; Location Of The Serial Number - Bunn Ultra Technical Training Manual

Installation

Site Requirements

Space
• Counter able to support 180 lbs (PAF Accessory Included).
• Minimum clearance of 6" between the machine side and the wall or another appliances
• Counter area able to accommodate machine's footprint with six inches of clearance in the rear
for air flow and air filter cleaning.
• Dispenser performs better if not placed near any heating appliance that exhausts heat on and
around dispenser.
• Ultra-1 approx. dimensions (H 32 x W 8 x D 24.5)
• Ultra-2 approx. dimensions (H 32 x W 16 x D 24.5)
Plumbing (PAF Only)
• A shut-off valve should be installed in the line before the machine.
• Cold water with an operating pressure between 20 and 90 psi (138 and 690kpa) from a 1/2 inch
or larger supply line with a shut off valve.
• A strainer assembly should be installed in line prior to the flexible water line.
Plumbing (LAF with Water to Product Ratio Brix Pump with Shut Off)
• Cold water with an operating pressure between 20 and 90 psi (138 and 690kpa) from a ½ inch or
larger supply line with a shut off valve.
• Water pressure regulator required and set to 50 psi (345kpa) or SHURflo water pressure
reducing valve.
• Double check valve with vent required after pressure regulator.
• 3 - Way Sanitizing Valve required within 6 inches of the brix pump
• Use 3/8 inch I.D. FDA approved flexible beverage tubing and stainless steel fittings with Oetiker
clamps.
Water Treatment
• Cold water hook-up only.
• Adequate space for water filter and maintenance.
• Water filter or water cartridge purged before machine installation.
• Installation date recorded on water filter decal.
Electrical
• 120VAC
• Dedicated 15AMP Circuit with proper breaker and receptacle
• Receptacle within 5 feet of machine
• Mating connector must be NEMA 5-15R

Location of the Serial Number

The machine's serial number is located on the data plate, which is located on
the right side panel. The serial number half tag can be found on the inside of the
machine on the main machine frame.
4
Ultra Training Manual