Exterior Overview; Product Outlets And Removable Parts; Removing The Enclosure - Bunn Ultra Technical Training Manual

Machine Composition

Exterior Overview

Product outlets and removable parts

• Hopper outlet(s)
• Drip tray
• Hopper(s)
• Auger(s)
• Faucet(s)
• Hopper lid(s)
• Air filter

Removing the Enclosure

The majority of the service work done to the ULTRA will require the service technician to access the inside of the
machine. The ULTRA enclosure is comprised of two side panels, front control panel and two top motor covers to
facilitate access to the refrigeration and electrical components.
Depending on the repair the technician may have to remove one or all of these panels. In order to work safely the
power should be disconnected prior to removal of any body panel. Once the panels and drip tray are removed, the
power can be reconnected in order to troubleshoot the machine.
Front Control Panel
Removing the front control panel will give you access to the main control board, Tic board, switch membrane ribbon
connection and hopper drip tray drain tubes.
How to Remove
The control panel is attached to the main housing by 1 hex slotted and 2 standard slotted screws.
Hopper Lid
Auger
Air Filter
(on back)
Hopper
Facuet
Drip Tray
Bunn-O-Matic Corporation
21