Mobotix D25M Manual page 71

Mounting The Camera With The In-Ceiling Set
7. Insert the camera and the In-Ceiling Set into the hole: Make sure that all winged
cams are retracted before placing the In-Ceiling Set with the camera into the hole.
Tightening the screws of the In-Ceiling Set extends the winged cams, thus firmly
holding the set in place.
8. Install the decorative ring: Use the two wrenches from
the In-Ceiling Set to place the ring on the set as shown
in the figure and turn the ring clockwise until it stops.
The two wrenches from the In-Ceiling Set are also used
for dismounting. Insert them as shown and turn the ring
counter-clockwise. Loosen the screws of the In-Ceiling
Set; this will automatically retract the winged cams. You
can now remove the In-Ceiling Set, with the camera still
attached, from the ceiling.
9. Proceed to Section 3.3.1, «Aiming and Adjusting The Lens» .
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
71
/140
The blue winged cams
(see left) automatically
secure the In-Ceiling
Set in the ceiling when
tightening the screws
Installing the decora-
tive ring:
turn clockwise
Removing the decora-
tive ring:
turn counter-clockwise
– only relevant when
completely remov-
ing the camera