Troubleshooting Guide - HAMPTON BAY HB-4190 Series Installation Manual

SYMPTOM POSSIBLE CAUSE
1. Light switch is turned off.
Light will not 2. Bulb is loose or burned out.
come on. 3. Fuse is blown or circuit
breaker is turned off.
4. Daylight turn-off is in effect
(recheck after dark) .
5. Incorrect circuit wiring, if
this is a new installation.
Light comes 1. Light Control may be in-
on in daylight. stalled in a relatively dark
location.
2. Light Control is in Test. (Set
control switch to an ON-
TIME position.)

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide.
SYMPTOM POSSIBLE CAUSE
Light comes 1. Light Control may be sens-
on for no ap-
parent reason.
Light stays 1. The sensor is pointed toward
on continu-
ously.
Light flashes 1. Light Control is in the Test
on and off.
6
ing small animals or auto-
mobile traffic (Reduce sen-
sitivity) .
a heat source like an air vent,
dryer vent, or brightly-painted
heat-reflective surface.
(Reduce sensitivity.)
mode and warming up.
(Flashing is normal under
these conditions) .
595-5770-01