Optional Wiring - HAMPTON BAY HB-4190 Series Installation Manual

❒ When wiring to additional standard
fixture only: Strip the motion sensor's
red wire and connect to the standard
light's black wire. Connect all white wires
together. Total fixture ratings must not
exceed 360 Watts (3.0 A.).
NOTE: All wiring between fixtures should be
run in accordance with the National Elec-
trical Code (Canadian Electrical Code in
Canada) through conduit or another ac-
ceptable means. Contact a qualified
electrician if there is any question as
to the suitability of the system.
BLACK
WHITE
Wiring to Motion Light &
Standard Fixture
595-5770-01

OPTIONAL WIRING

BLACK
RED
(Standard)
❒ This fixture is provided with a sensor rated
for 360 Watts. Since the fixture is only rated
100 Watts (180 Watts candelabra), 260
Watts (180 Watts candelabra) of additional
load may be controlled by this sensor.
❒ When determining what a fixture is rated
for, do not simply look at the rating on the
lamp in the fixture. Look at the marking
which specifies the maximum lamp watt-
age for which the fixture is suitable.
❒ Once you have selected the fixtures to be
connected and determined their maxi-
mum ratings, add these ratings up. For
instance, if you have 3 fixtures rated 100
Watts, 150 Watts, and 75 Watts respec-
tively, you have a total load of 325 Watts.
BLACK
Wiring to Control One Motion Sensing
Lantern (Slave) from Another (Master)
3
Master
RED
BLACK
WHITE
Slave