Troubleshooting Guide - HAMPTON BAY HB-4190 series User Manual

SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect
(recheck after dark).
5. Incorrect circuit wiring, if this is
a new installation.
Light comes on 1. Light control may be installed
in daylight.
in a relatively dark location.
2. Light control is in Test. (Set
control switch to an ON-TIME
position.)
Light comes on
1. Light control may be sensing
for no apparent smallanimalsorautomobiletraffic
reason.
(Reduce sensitivity).
2. Sensitivity is set too high. (Re-
duce sensitivity.)
No Service Parts Available for this Product

TROUBLESHOOTING GUIDE

If you experience a problem, follow this guide.
SYMPTOM POSSIBLE CAUSE
Light stays on
1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes
1. Light control is in the Test
on and off.
2. Heat being reflected from other
8
a heat source like an air
vent, dryer vent, or brightly-
painted heat-reflective surface.
(Reduce sensitivity.)
(Switch to Auto.)
ual
mode.
duce sensitivity.)
mode and war ming up.
(Flashing is normal under
these conditions).
objects may be affecting the
sensor. (Reduce sensitivity.)
595-5770-06
B
®
rite