Clone Mode - Kenwood TK-360G Service Manual

TK-360G/(N)/370G/(N)
6. Check the connection between the TK-360G/370G and the
personal computer, and make sure that the TK-360G/370G
is in Program mode.
7. Press F10 on the personal computer. A window opens on
the display to indicate the writing progress. When the TK-
360G/370G begins to receive data, the LED lights green.
8. When data is received successfully, a checksum appears
on the display.
(Since the TK-360G does not have a display, check the
checksum with the FPU (KPG-56D).)
9. If you want to continue programming other TK-360G/
370Gs, repeat steps 5 to 8.
Notes:
To start the Firmware Programmer from KPG-56D, the Fpro
path must be set up by the KPG-56D Setup.
This mode cannot be entered if the Firmware Programming
mode is set to Disable in the Programming software (KPG-56D).

7. Clone Mode

Programming data can be transferred from one radio to
another by connecting them via their SP/MIC connectors. The
operation is as follows (the transmit radio is the master and
the receive radio is the slave).
1. Turn the master TK-370G power ON with the [Side1]+[3]
key held down. The TK-370G displays "
2. Power on the slave TK-360G/370G.
3. Connect the cloning cable to the SP/MIC connectors on
the master and slave.
°
4. Press the [ ] key on the master while the master displays
" CLONE ". The data of the master is sent to the slave.
While the slave is receiving the data, "-PC-" is displayed.
When cloning of data is completed, the master displays
"END", and the slave automatically operates in the User
mode. The slave can then be operated by the same program
as the master.
Slave TK-360G
E
TK-370G
Master
E
TK-370G
OK
E
TK-370G
N/A
(N)E
10
REALIGNMENT
CLONE ".
TK-360G TK-360G TK-360G
(N)E E4
TK-370G
(N)E
N/A N/A
OK N/A
When programming the firmware, it is recommend to copy
the data from the floppy disk to your hard disk before you
update the radio firmware.
Directly copying from the floppy disk to the radio may not
work because the access speed is too slow.
6-4. Function
1. If you press the [Side2] switch while "PROG XXX" is
displayed, the checksum is displayed. If you press the
[Side2] switch again (while the checksum is displayed),
"PROG XXX" is redisplayed.
2. A transmission speed can be selected by pressing the [Side1]
switch while "PROG XXX" is displayed.
19200 bps: The LED flashes green and red alternately.
38400 bps: The LED flashes orange.
57600 bps: The LED lights orange.
Note:
Normally, write in the high-speed mode.
5. The other slave can be continuously cloned. When the [
key on the master is pressed while the master displays
"END", the master displays "
operation in steps 2 to 4.
Note: You can clone the programmed data between the
transceiver listed below.
Frequency version must be same.
Use the new clonig cable for TK-360G/370G.
You cannot use the old cloning cable for TK-360/370.
TK-862 TK-862
(N)E4 E
N/A OK
N/A N/A
CLONE ". Carry out the
(N)E
N/A
OK
°
]