Kenwood TK-360G Service Manual page 12

Cloning cable parts No.
E30-3410-05 (TK-370G→TK-360G/370G)
GND
PTT/RXD
REMOTE/TXD
Cloning cable
Fig. 2
8. Self Programming Mode (TK-370G)
Write mode for frequency data and signalling etc. Mainly
used by the person maintaining the user equipment.
8.1 Self programming mode setting
Remove D17 from the TX-RX unit (Figure 3) (K, K4, E, (N)E
models only). Hold down the [Side1]+[ ] switches and turn
the power switch on.
When the self programming mode is entered, [SELF]
appears on the display. The mode changes automatically
to Model Select Mode and "PORTABLE" is displayed in
about one second.
Note :
This mode (self programming mode) cannot be set when it
has been disabled with the FPU.
Note :
Self Programming is disabled if "a Trunking Board is
installed in this Radio" is selected in FPU.
Flow Chart
Radio type
[2]
Radio Band & Channel Type
[2]
Frequency Version
[2]
[3]
Self programming mode
[Side2]
Channel set mode
Function set mode
Note :
IF the radio type of TK-370G was temporally set to "Mobile"
for the cloning purposes, "UNPROG" is displayed (at User
TK-360G/(N)/370G/(N)
REALIGNMENT
Portable Mobile
[CH]
M models only
VHF 8CH VHF 16CH
[CH] [CH]
VHF F1 VHF F2 UHF F1
[CH] [CH]
[Side1]
E30-3411-05 (TK-370G→TK-860G/862G)
GND
PTT/RXD
REMOTE/TXD
8
1
[CH]
VHF 128CH UHF 8CH
[CH] [CH]
[CH]
UHF F2 UHF F3
[CH] [CH]
Mode) when the TK-370G is turned on.
In this case, please set the radio type back to "Portable" at
Model Select Mode menu.
1
MBL
PSB
GND
PTT/RXD
ME
MIC
REMOTE/TXD
8 CM
X57-588X
Compoent Side
D17
Fig. 3
M models only
UHF 16CH UHF 128CH
[CH]
Frequency version
UHF F4
selection that
[CH]
matches Radio
Band and Channel
Type appears.
11