Clone Mode - Kenwood TK-7108H Service Manual

4. Clone Mode

Programming data can be transferred from one radio to
another by connecting them via their modular microphone
jacks. The operation is as follows (the transmit radio is the
master and the receive radio is the slave).
Note :
Clone mode should enabled.
1. Turn the master TK-7108H power ON with the [1] key held
down. The TK-7108H [●] LED is turned on.
2. Power on the slave TK-7108H.
3. Connect the cloning cable (No. E30-3382-05) to the modu-
lar microphone jacks on the master and slave.
4. Press the [●] key on the master TK-7108H transceiver.
The data of the master is sent to the slave. While the mas-
ter is sending data, [TX] LED blinked. While the slave is
receiving the data, 4 LEDs, [MON] LED, [●] LED are
turned on and [BUSY] LED blinked. When cloning of data
is completed, the master [TX] LED turned off, and the
slave automatically operates in the User mode. The slave
can then be operated by the same program as the master.
5. The other slave can be continuously cloned. Carry out the
operation in step 2 to 4.
4-1. Adding the data password.
If the data password is set in the optional feature menu,
you must enter the password (Master transceiver) to activate
a clone mode.
you can use 1, 2, 3, and 4 to configure the password. The
maximum length of the password is 10 digits.
1. [1]+Power ON.
2. [1]~[4] LED, and MON LED are turned ON.
3. Enter the password using [1]~[4] keys.
4. Press [MON] key.
5. If the password matches, the transceiver enters a clone
mode. Otherwise, transceiver beeps and returns to the
password input mode.
Clone cable
(E30-3382-05)
Fig. 2
REALIGNMENT
5. Accessory Connection Cable (KCT-39)
The KCT-39 is an accessory connection cable for connect-
ing external equipment. The connector has 15 pins and the
necessary signal lines are selected for use.
5-1. Installing the KCT-39 in the Transceiver
1. Lift the DC cord bushing (
pad as shown in Figure 3 (
2. Stick the pad to the DC cord (
of which are supplied with the KCT-39.
TK-7108H
) from the chassis. Peel the
1
).
2
1
2
Fig. 3
) and chassis (
3
3
4
Fig. 4
), both
4
9