General; System Set-Up - Kenwood TK-360G Service Manual

TK-360G/(N)/370G/(N)
INTRODUCTION
SCOPE OF THIS MANUAL
This manual is intended for use by experienced technicians
f a m i l i a r w i t h s i m i l a r t y p e s o f c o m m e r c i a l g r a d e
communications equipment. It contains all required service
information for the equipment and is current as of the
publication date. Changes which may occur after publication
are covered by either Service Bulletins or Manual Revisions.
These are issued as required.
ORDERING REPLACEMENT PARTS
When ordering replacement parts or equipment
information, the full part identification number should be
included. This applies to all parts, components, kits, or chassis.
If the part number is not known, include the chassis or kit
number of which it is a part, and a sufficient description of the
required component for proper identification.
Unit
Model & TX-RX Unit
destination
E X57-5882-71
(N)E X57-5882-72
TK-360G
E4 X57-5882-76
(N)E4 X57-5882-75
E X57-5882-73
TK-370G
(N)E X57-5882-74

SYSTEM SET-UP

Merchandise received
Choose the type of transceiver
Transceiver programming
Are you using the speaker microphone?
2
GENERAL / SYSTEM SET-UP
Display Unit Frequency range
440~470MHz
–
403~430MHz
X54-3250-10 440~470MHz
A personal computer (IBM PC or compatible), programming
interface (KPG-22), and programming software (KPG-56D)
are required for programming.
(The frequency, TX power HI/LOW, and signalling data are programmed
for the transceiver.)
YES
NO
Delivery
PERSONNEL SAFETY
The following precautions are recommended for personnel
safety:
DO NOT transmit until all RF connectors are verified secure
and any open connectors are properly terminated.
SHUT OFF and DO NOT operate this equipment near
electrical blasting caps or in an explosive atmosphere.
This equipment should be serviced by a qualified technician only.
SERVICE
This radio is designed for easy servicing. Refer to the
schematic diagrams, printed circuit board views, and alignment
procedures contained within.
NOTE
The terms "Wide" and "Semi wide" used in this service
manual correspond to "Wide 5K" and "Wide 4K" respectively
that appear in the menu and help texts of the KPG-56D (Field
Programming Unit).
Remarks Whip Antenna
IF1 : 44.95MHz
LOC : 50.4MHz
Frequency range (MHz) RF power
TX/RX 440~470
TX/RX 440~470
TX/RX 403~430
KMC-17 or KMC-21
Speaker microphone
(Option)
Charger Battery
O OP OP
Type
4.0W TK-360G E TK-370G E
4.0W TK-360G (N)E TK-370G (N)E
4.0W TK-360G E4, (N)E4
16 Key
–
O