Clone Mode - Kenwood TK-980 Service Manual

6-4. Function
1. If you press the [MON] switch while "PROG 57600" is
displayed, the checksum is displayed. If you press the
[MON] switch again while the checksum is displayed,
"PROG 57600" is redisplayed.
2. If you press the [D] switch while "PROG 57600" is dis-
played, the display changes to "PROG 19200" to indicate
that the write speed is low speed (19200 bps). If you
press the [D] switch again while "PROG 19200" is dis-
played, the display changes to "PROG 38400", and the
write speed becomes the middle speed (38400 bps). If
you press the [D] switch again while "PROG 38400" is
displayed, the display returns to "PROG 57600".
Note :
Normally, write in the high-speed mode.

7. Clone Mode

Programming data can be transferred from one radio to
another by connecting them via their modular microphone
jacks. The operation is as follows (the transmit radio is the
master and the receive radio is a slave).
1. Turn the master radio power ON with the [C] key held
down. If the password is set to the radio, the radio dis-
plays "CLONE LOCK". If the password is not set, the
radio displays "CLONE MODE".
2. When "CLONE LOCK" is displayed, only the [System up/
down] key and [SCN], and [0] to [9] keys can be accepted.
When you enter the correct password, and "CLONE
MODE" is displayed, the radio can be used as the cloning
master. The following describes how to enter the pass-
word.
3. How to enter the password with the microphone keypad.
If you press a key while "CLONE LOCK" is displayed, the
number that was pressed is displayed on the radio. Each
press of the key shifts the display in order to the left.
When you enter the password and press the [SCN] key,
"CLONE MODE" is displayed if the entered password is
correct. If the password is incorrect, "CLONE LOCK" is
redisplayed.
How to enter the password with the [System up/down]
key;
If the [System up/down] key is pressed while "CLONE
LOCK" is displayed, numbers (0 to 9) are displayed flash-
ing. When you press the [SCN] key, the currently se-
lected number is determined, and the display shifts to
the left. If you press the [SCN] key after entering the
password in this procedure, "CLONE MODE" is dis-
played if the entered password is correct. If the pass-
word is incorrect, "CLONE LOCK" is redisplayed.
4. Power on the slave radio.
5. Connect the cloning cable (No. E30-3382-05) to the
modular microphone jacks on the master and slave.
REALIGNMENT
6. Press the [SCN] key on the master while the master dis-
plays "CLONE MODE". The data of the master is sent to
the slave. While the slave is receiving the data, "PRO-
GRAM" is displayed. When cloning of data is completed,
the mater displays "END", and the slave automatically
operates in the User mode. The slave can then be oper-
ated by the same program as the master.
7. The other slave can be continuously cloned. When the
[SCN] key on the master is pressed while the master dis-
plays "END", the master displays "CLONE MODE".
Carry out the operation in step 4 to 6.
Note :
Only the same models can be cloned together.
Cloning cable
(E30-3382-05)
TK-980/981
Fig. 2
15