Normal System Operation; Keypad Led Status Indicators; Tamper Alarm - Essex Electronics K1 Series Installation Instructions Manual

Normal System Operation

Keypad LED Status Indicators

! ! ! ! !
! A solid green LED indicates that the door is unlocked.
! A solid red LED indicates that the door is locked.
Depending on how the System Options are configured, User
Commands are used to operate Manual Latching. The User
Commands are trailing digits entered after an authorized user
code followed by #. The ability to use these User Commands
depends on authorizations assigned to each User (see Program-
ming Individual Users, page 17).
As the Main Output activates, the green LED will flash for 5
seconds. While the green LED is flashing, enter one (or more) of
the following User Commands:
0 # to Latch the Door Closed (Main Relay, 2
1 # to Latch the Door Open (Main Relay, 2
2 # to Turn Output A OFF (2
3 # to Turn Output A ON (2
4 # to Turn Output B OFF (3
5 # to Turn Output B ON (3

Tamper Alarm

! ! ! ! !
An audible Tamper Alarm sounds when four incorrect code entries
are made. After 30 seconds, the unit returns to standby mode.
22
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
Output as Aux.)
nd
Output as Aux.)
nd
Output as Aux.)
rd
Output as Aux.)
rd
Door or 3 Door)
nd rd
Door or 3 Door)
nd rd