Page 1
SPACE HEATERS JUMBO Ed. 06/08 JUMBO INSTRUCTIONS MANUAL...
Page 2
- e-mail: bm2@biemmedue.com MODEL JUMBO 65 M, 65 T, 90 M, 90 T, 90 M/C, 115 M, 115 T, 115 M/C, 115 T/C JUMBO 150 M, 150 T, 150 M/C, 150 T/C, 200 M, 200T, 200 T/C Before using the heater, read and understand all instructions and follow them carefully.
Page 3
CONTROL BOARD - TABLEAU DE COMMANDE CONTROL LAMP CONTROL KNOB HEAT - STOP - VENTILATION ONLY POWER CORD FASTENER OVERHEAT SAFETY THERMOSTAT, L1 FAN THERMOSTAT, F LIMIT THERMOSTAT WITH MANUAL RESTART, L2 THERMOSTAT RESET SWITCH HOUR COUNTER OVERHEAT THERMOSTATS CONTROL LAMP, L1, L2 10 FAN STOP CONTROL LAMP 11 HEATED DIESEL FILTER PLUG 12 BURNER PLUG...
The air outlet can be replaced by outlet panels with two or four openings, all of which must be kept open. Warning Jumbo heaters can operate with burners that are fuelled by diesel oil The following operations must be carried out by quali- #2 max., natural gas or propane.
that: used, burners shall be adapted according to the instruction manual of the burner. • The fan motor does not absorb more current than the maximum In case of connection of heater to natural gas,the installation shall permitted limit; • The volume of air flow corresponds to the recommended level. conform with local codes, or, in the absence of local code, with the Na- If the heater is equipped with centrifugal fan and if the volume of tional Fuel Gas Code ANSI Z223.1/NFPA and the Natural Gas and...
Page 6
• Stop the machine as instructed above TRANSPORTING AND MOVING THE HEATER • Turn off the disconnecting switch on the electric To move the Jumbo use the front handles and back wheels. switchboard. • Wait until the heater has cooled.
Page 7
OBSERVED FAULTS, CAUSES AND REMEDIES OBSERVED FAULT CAUSE REMEDY • Check function and positioning of main switch • Check power cord • Faulty electrical supply • Check electrical connections • Check fuses • The heater won’t start • Wrong positioning of main switch •...
Need help?
Do you have a question about the Jumbo and is the answer not in the manual?
Questions and answers