Jenn-Air JEC0530ADB Service page 19

Installation Instructions
Junction Box Connection
Junction box is not supplied with cooktop. Junction box
must be U.L. or C.S.A. listed and meet NEC and Mobile
Home Manufactures Association Standards.
• Three-wire conductor junction box allowed for
residential usage in United States.
• Four-wire conductor junction box required in Canada
and for most mobile home installations, but can be
used for residential.
• Refer to local, municipal, and state building codes.
NOTE: A power cord must not be used.
Red House
Wire
Black
House Wire
Red
Cooktop Wire
Black
Cooktop Wire
3-Wire Electrical Installation
United States Only
Red House
Wire
Black
House Wire
Red
Cooktop Wire
Black
Cooktop Wire
4-Wire Electrical Installation
United States or Canada Only
©2004 Maytag Services
Notice To Installer
Follow accompanying instruction carefully.
Preparation Of Countertop
The cutout in the countertop into which the appliance is to
be installed should be prepared according to the cutout
dimensions given on page 1 of these instructions.
White
House Wire
Installation Of Appliance
White
1. Remove the cooktop from the carton and place it
Cooktop Wire
Green
Cooktop Wire
2. Provide cutout in countertop.
3. Place unit in the cutout.
4. Make electrical wire connection to unit. Consult local
5. Test to insure control knobs operate all elements
Green
House Wire
White
House Wire
White
Cooktop Wire
Green
Cooktop Wire
16023537
!
CAUTION
Never use a metal blade to pry knob off. If knob cannot
be easily removed, tuck folds of a dish- towel under
knob skirt and pull upward with steady, even pressure.
!
CAUTION
Cutout dimensions are critical. Dimensions must be
measured and cut accurately to within + 1/16" (.16 cm)
to insure proper fit.
upside down over two soft pads making sure control
knobs do not interfere with any surface.
codes for proper power hook-up.
properly.
A–3