Asus Vintage V2-AH2 Manual page 88

Primary Display Adapter [PCI-E]
Allows you to select a graphics controller as the primary boot device.
Configuration options: [PCI] [Onboard] [PCI-E]
Resources Controlled By [Auto]
When set to [Auto], the BIOS automatically configures all the boot and Plug
and Play compatible devices. Set to [Manual] if you want to assign the IRQ
DMA and memory base address fields.
Configuration options: [Auto] [Manual]
When the item Resources Controlled By is set to [Auto], the item IRQ
Resources is grayed out and not user-configurable. Refer to the section
"IRQ Resources" for information on how to enable this item.
IRQ Resources
This sub-menu is activated only when the Resources Controlled By item is
set to Manual.
Advanced
IRQ-3 assigned to
IRQ-4 assigned to
IRQ-5 assigned to
IRQ-7 assigned to
IRQ-9 assigned to
IRQ-10 assigned to
IRQ-11 assigned to
IRQ-12 assigned to
IRQ-14 assigned to
IRQ-15 assigned to
F1:Help
ESC: Exit
IRQ-xx assigned to
When set to [PCI Device], the specific IRQ is free for use of PCI/PnP
devices. When set to [Reserved], the IRQ is reserved for legacy ISA
devices. Configuration options: [PCI Device] [Reserved]
Maximum Payload Size [4096]
Sets the maximum payload size in bytes for PCI Express devices.
Configuration options: [128] [256] [512] [1024] [2048] [4096]
5-24
Phoenix-Award BIOS CMOS Setup Utility
IRQ Resources
↑↓ : Select Item
→←: Select Menu
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
[PCI Device]
-/+: Change Value
Enter: Select Sub-menu
Select Menu
Item Specific Help
Legacy ISA for devices
compliant with the
original PC AT bus
specification, PCI/ISA
PnP for devices
compliant with the
Plug and Play standard
whether designed for
PCI or ISA bus
architecture
F5: Setup Defaults
F10: Save and Exit
Chapter 5: BIOS setup