5.5 Suction Line Thermistor Replacement
NOTE: The following procedure may be the easiest, but, it is not the only way
replace the thermistor.
1. Unplug the ice machine and remove the top and front panels.
2. Remove plastic rivets from the
electrical box mounting bracket using a
punch and side cutters. Save the rivets
for reinstallation.
3. Remove and retain four screws on top
of bracket and two on gauge port bracket.
4. Move electrical box out of the
way and cut insulation from
around the thermistor.
5. Replace thermistor. Be sure to clean the surface
of the suction line.
© 2001, IMI Cornelius Inc.
I-Series Ice Machine Training Manual
Punch thru
center of rivet
Remove 2 screws
Remove 4 screws
Thermistor
Thermistor
Side cutters to lift
rivets Do Not Cut
Groove
in line
- 15 -