Specifications - CNC4PC C11G User Manual

C11G (Rev.7.1) User Manual
example, if you are using output pin
#1 to control
Electromechanical Relay, you can
also access that signal from the

3. Specifications.

! ""
! ""
! " $
% & %
!
%
! ""
! " $
% & %
" ' '
*Time passed since a low in the ENABLE input is detected and the outputs are disabled
Requirements:
It requires a 5VDC @ 800 milliamps power supply to operate.
WARNING
Check the polarity and voltage of the external power source and connect the 5V
and GND. Overvoltage or reverse-polarity power applied to these terminals can
cause damage to the board, and/or the power source.
Revision: 28/01/2009
the Built-in
#
%
#
%
&
http://cnc4pc.com/TechDocs/C11GR7_1_User_Manual.pdf 3/19
output pin on the board or from the
DB25 connector for output. Each
connection will not affect the other
current from the other connection.
#
! "