D-Link DAP-3220 User Manual page 60

DAP-3220 User's Manual
2. The wireless client cannot access the Internet within Infrastructure mode.
Make sure the wireless client is associated and joined with the correct access point. To check
this connection, right-click on the Local Area Connection icon in the taskbar and select View
Available Wireless Networks. The Connect to Wireless Network screen will appear. Please
make sure you have selected the correct available network, as shown in the illustrations below.
 Check that the IP address assigned to the wireless adapter is within the same IP address
range as the access point and gateway. Since the DAP-3220 has an IP address of
192.168.0.50, wireless adapters must have an IP address in the same range, e.g. 192.168.0.x.
Each device must have a unique IP address; there may be no two devices with the same
IP address. The subnet mask must be the same for all the computers on the network. To
check the IP address assigned to the wireless adapter, double-click on the Local Area
Connection icon in the taskbar, then select the Support tab and the IP address will be
displayed. Please refer to Checking the IP Address in the Networking Basics section of
this manual.
 If it is necessary to assign a Static IP Address to the wireless adapter, please refer to the
appropriate section in Networking Basics. If you are entering a DNS Server address you
must also enter the Default Gateway Address. Remember that if you have a DHCP-capable
router, you will not need to assign a static IP address. See Networking Basics: Assigning
a Static IP Address.
D-Link Wireless 108G Exterior Access Point
Troubleshooting
60