Pitco MG14S-C/MFD Service Manual page 18

13. Remove the complete splash back assembly.
14. Remove the lower rear back cover.
15. Unscrew the compression fitting at the rear of
the vat.
16 Remove the air tube from the air box (the blower
is mounted to this box).
17. Grasp the vat by the middle tube and remove it
from the rear of the cabinet.
Split vats-
Split vats should be removed and installed as pairs
in the same manner as Full Vats. There are 3 sets of
clamps that hold the two Split Vats together:
1. On the rear of the vat.
2. On the bottom of the vat accessed by first re-
moving the blower.
3. On the bottom of the vat at the front.
NOTE: To disconnect the filter return piping (as in
step # 15) unscrew the union connecting the return
piping to the vats.
Install in the reverse order.
14