Glass Media Assembly And Partially Reflective Panel Replacement; Thermistor Replacement - Dimplex DF2024 Service Manual

GLASS MEDIA ASSEMBLY AND
PARTIALLY REFLECTIVE PANEL
REPLACEMENT
Tools Required: Phillips Head Screwdriver
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the firebox from the back of the mantel by
removing the retaining screws which secure the firebox
brackets to the mantel.
3. Remove the three screws along the back of the unit
and the two on either side along the bottom edge.
(Figure 6)
4. Lay the Compact Fireplace on its back.
5. Gently open the bottom panel, laying it on the work sur-
face so that all of the components can easily be seen.
(Figure 7)
6. Remove the two screws on each side that secure the
glass media support brackets to the firebox. (Figure 9)
7. Remove the glass media and the support bracket.
8. If required remove the partially reflective panel by slid-
ing it out of the side channels towards the bottom.
9. Reassemble in the reverse order as above.
Figure 9

THERMISTOR REPLACEMENT

Tools Required: Phillips Head Screwdriver
at least 10 minutes for lights, heating elements and top
panel to cool off to avoid accidental burning of skin.
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the firebox from the back of the mantel by
3. Remove the three screws along the back of the unit
4. Lay the Compact Fireplace on its back.
5. Gently open the bottom panel, laying it on the work sur-
!
Glass Media assemblies.
6. Remove the two screws on each side that secure the
7. Remove the glass media and the support bracket.
!
logset assemblies.
8. Remove the two screws that secure the front glass
9. Remove the front glass and set aside in a safe place.
10. Remove the retaining screw in the front middle of the
11. Pull the front edge of the plastic Ember Bed or plastic
! IMPORTANT: Only handle the Log Set by the Ember
Bed.
! NOTE: Log Set fits tightly into firebox, some force may
be necessary to remove.
Support Bracket
Screws 12. Remove the partially reflective panel by sliding it out of
13. Locate and release the thermistor from the back panel
14. There is one connection located on the display/control
15. Install the new thermistor.
16. Reassemble in the reverse order as above.
CAUTION: If unit was operating prior to servicing allow
WARNING: Disconnect power before attempting any
removing the retaining screws which secure the firebox
brackets to the mantel.
and the two on either side along the bottom edge.
(Figure 6)
face so that all of the components can easily be seen.
(Figure 7)
NOTE: Steps 6-7 are only applicable for units with
glass media support brackets to the firebox. (Figure 9)
NOTE: Steps 9-11 are only applicable for units with
retaining bracket to the unit. (Figure 5)
grate.
grate up and forward until the rear tab releases from
the ledge located at the bottom of the Partially Reflect-
ive Panel. (Figure 8)
the side channels towards the bottom.
by using needle nose pliers to depress the tab on the
mounting standoffs and gently lift the board off.
board that may require the board to be removed. This
can be done by removing the two screws on the right
hand side of the unit to remove the display/control
board to remove the connection and replace it with the
new one.
11