NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
OPERATION Remote Control The fireplace is supplied with a radio frequency remote Figure 1 control. This remote control has a range of approximately 50 feet (15.25 m), it does not have to be pointed at the fireplace and can pass through most obstacles (including walls).
Reach into the opening, locate and examine the bulbs to determine which bulb(s) require replacement. Unscrew the bulb(s) counter clockwise. Insert new bulb(s). Install the light access cover and install the screws. Figure 3 Light Bulbs Screws Light Access Cover www.dimplex.com...
Depress the retainer clips on the rear of the switch and push the switch out of the bottom access panel. On/Off/Remote Switch Properly orient the new switch and connect all of the wiring connections. Reassemble in the reverse order as above. www.dimplex.com...
FLICKER MOTOR & REFLECTOR Figure 6 ASSEMBLY REPLACEMENT Mounting Screws Tools Required: Phillips Head Screwdriver Flat Head Screwdriver CAUTION: If unit was operating prior to servicing allow at least 10 minutes for lights, heating elements and top panel to cool off to avoid accidental burning of skin. Control Knob WARNINg: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage...
WARNINg: Disconnect power before attempting any maintenance to reduce the risk of electric shock or damage to persons. Unplug the unit from power outlet. Remove the firebox from the back of the mantel by removing the retaining screws which secure the firebox www.dimplex.com...
MIRROR REPLACEMENT BUILT-IN REMOTE RECEIVER / CIRCUIT BOARD REPLACEMENT CAUTION: If unit was operating prior to servicing allow at least 10 minutes for lights, heating elements and top CAUTION: If unit was operating prior to servicing allow panel to cool off to avoid accidental burning of skin. at least 10 minutes for lights, heating elements and top panel to cool off to avoid accidental burning of skin.
Page 12
NOTE: Dependent on the age of the unit the sock- ets may be secured with either a screw ring or a snap in socket. Attach the replacement sockets into the each socket opening on the housing panel/bracket. Re-assemble the compact fireplace in reverse order. www.dimplex.com...
TROUBLESHOOTINg gUIDE PROBLEM CAUSE SOLUTION general Circuit breaker trips or fuse Short in unit wiring. Trace wiring in unit. blows when unit is turned on Improper circuit current rating Additional appliances may exceed the current rating of the circuit breaker or fuse. Plug unit into another outlet or install unit on a dedicated 15 amp circuit.
Page 14
Grinding or excessive noise with Moving flame rod hitting or rubbing Ensure rod is straight and mounted properly in the the heater off against internal components bracket, spinning freely away from other components. Replace if necessary. Defective flame motor Replace flame motor www.dimplex.com...