Operation - Dimplex DF2024 Service Manual

OPERATION

Figure 1
On Screen
Display
The unit can be controlled by either the manual controls
which are located on the upper right of the fireplace or the
remote (Figure 1 & 2).
The fireplace is supplied with an IR multifunction remote
control.
! NOTE: To operate correctly, the remote control must be
pointed towards the front of the unit.
A. Standby
Turns the unit On and Off.
→ Activated by pressing the Standby button on the remote
or the unit.
• The unit will turn on with the same functions that it was
set to when it was turned Off and the intake temperature
will be indicated on the On Screen Display.
! NOTE: When any button is pressed the intake tem-
perature will be displayed on the On Screen Display for 5
seconds.
B. Flame Effects
The Flames can be turned off by pressing the
then again to turn back on.
→ Activated by pressing the
unit.
C. Heat ON/OFF
Turns the heater function On and Off based on the thermo-
stat setpoint.
→ Activated by pressing the
remote.
• Indicated by the icon and the intake temperature be-
ing displayed on the On Screen Display, for 5 seconds
before turning off.
! NOTE: The unit can be operated in Heat Only Mode.
When the unit is only running with the heater, the
and the intake temperature will continuously be displayed
on the On Screen Display.
! NOTE: The heater may emit a slight, harmless odor
when first used. This odor is a normal condition caused
by initial heating of internal heater parts and will not occur
A B C F
F
C
button,
button on the remote or the
button on the unit or the
icon
Figure 2
A
D
B
again.
D & E. Thermostat Controls
Adjusts the temperature set point to your individual require-
ments. Once the desired set temperature is reached the
heater will turn off. The heater will cycle on and off to main-
tain the desired set temperature. The default temperature
setting is 72°F (22°C).
→ Adjusted by pressing the
and the to increase the setpoint on the remote.
• The On Screen Display will indicate the temperature set-
point as it is adjusted.
! NOTE: Holding the
change the temperature from °C to °F, or vice versa.
Disable Heat
If desired, depending on the season, the heater on the unit
can be disabled. The unit will operate in the same fashion,
with the remainder of the controls.
Pressing the and buttons on the unit at the same
time and holding for 2 seconds will disable and enable the
heater.
! NOTE: When the heater has been disabled and either
the or the is pressed the On Screen Display will in-
dicate "--".
F. Sleep Timer
The Sleep Timer can be set to automatically shut off the
fireplace after a preset time (from 30 minutes to 8 hours).
→ To set the timer press the timer button on either the
remote or the unit, repeatedly, until the desired time is dis-
played.
• The On Screen Display will display the different times as
it is adjusted. Once the timer has begun, pressing the
button will display the time remaining before the unit
turns Off.
! NOTE: The Sleep Timer can be cancelled at any time
by pressing the button repeatedly until the sleep timer
displays nothing.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without being
E
F
C
to decrease the setpoint
button down on the unit will
3