Table of Contents
Advertisement
PARTIALLY REFLECTIVE GLASS
REPLACEMENT
Tools Required: Phillips head screwdriver
WARNING: If the fireplace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. On either side of the firebox, remove the retaining
screws and carefully remove the glass assembly from
the rest of the assembly. (Figure 3)
2. Carefully remove the acrylic media from the front tray.
3. If applicable, remove the fireplace assembly from the
wall by carefully lifting it upward, releasing it from the
flanges of the wall-mounting bracket. (Figure 4).
4. Carefully set the unit upright on a flat working surface.
! NOTE: If necessary, lay a protective barrier between
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
5. On the right end, with the switchboard, remove the ten
screws around the outside of the end panel. (Figure 5)
6. Lay unit on its back and remove the remaining 9 screws
from the end panel.
Figure 3
Figure 4
Glass Retaining
Screw
Wall Bracket
7. Remove the end panel being
Figure 5
8. Gently guide the partially reflec-
9. Re-assemble the remainder of
To Remove
! NOTE: Be sure that the flanges
on the end panel are positioned on
the interior of the outside panel of
the fireplace.
SWITCHBOARD REPLACEMENT
Tools Required: Phillips head screwdriver
Small adjustable wrench
WARNING: If the fireplace was operating prior to ser-
vicing, allow at least 10 minutes for light bulbs and heating
elements to cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. On either side of the firebox, remove the retaining
screws and carefully remove the glass assembly from
the rest of the assembly. (Figure 3)
2. Carefully remove the acrylic media from the front tray.
3. If applicable, remove the fireplace assembly from the
wall by carefully lifting it upward, releasing it from the
flanges of the wall-mounting bracket. (Figure 4).
4. Carefully set the unit upright on a flat working surface.
! NOTE: If necessary, lay a protective barrier between
the unit and your work surface, (i.e. cloth, cardboard, thick
plastic) to avoid scratching your work surface.
5. On the right end, with the switchboard, remove the ten
screws around the outside of the end panel. (Figure 5)
6. Lay unit on its back and remove the remaining 9 screws
from the end panel.
7. Remove the end panel being careful not to add any
strain to the wires connecting to the switchboard. (Fig-
ure 6)
8. Gently guide the partially reflective glass out the open
side of the firebox.
9. Follow the switchboard wiring to the display/control
board and replace the old connection with the new con-
nection.
10. Locate and remove the defective switchboard.
11. Install the new switchboard.
12. Re-assemble the remainder of the fireplace in reverse
order from the instructions above.
careful not to add any strain
to the wires connecting to the
switchboard.
tive glass out the open side of
the firebox and replace with new
piece.
the fireplace in reverse order from
the instructions above.
7
Advertisement
Table of Contents
