Partially Reflective Glass Replacement; On/Off Switch Replacement - Dimplex DF3033ST Service Manual

Partially Reflective Glass Replacement

WARNING: If unit was operating prior to servicing allow
at least 10 minutes for light bulbs and heating element to
cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
Tools Required: Phillips head Screwdriver
1. Slide fireplace out from mantel.
2. Remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it may
break if bumped, struck of dropped. Care must be taken
when handling the glass.
3. Pull the front edge of the plastic Ember Bed or plastic
grate up and forward until the rear tab releases from the
ledge located at the bottom of the Partially Reflective
Glass.
!
IMPORTANT: Only handle the Log Set by the Ember
Bed.
!
NOTE: Log Set fits tightly into firebox, some force may
be necessary to remove.
4. Set Log Set in front of fireplace.
5. Disconnect the Log Set LED wire harness from unit.
6. Loosen but do not remove the two (2) Philips screws that
clamp the Partially Reflective Glass in place, and swivel
down so that the clamp clears the edge of the Partially
Reflective Glass (Figure 7).
7. Push the Partially Reflective Glass out from behind to
clear the frame and remove.
8. Insert replacement Partially Reflective Glass top end first
and lay the bottom end gently in the bottom track of the
frame.
9. Swivel the clamps back into place. Tighten clamps
and reassemble fireplace in reverse order as described
above.

On/Off Switch Replacement

WARNING: If unit was operating prior to servicing allow
at least 10 minutes for light bulbs and heating element to
cool off to avoid accidental burning of skin.
Figure 7
Partially Reflective
Glass
Clamp (2)
Figure 8
- Screws To Remove for Top Cover
- Screws to Remove for Baffle (3 per side)
WARNING: Disconnect power before attempting any
maintenance or cleaning to reduce the risk of electric
shock or damage to persons.
Tools Required: Phillips head Screwdriver
1. Remove the firebox from the mantel.
2. Remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it may
break if bumped, struck of dropped. Care must be taken
when handling the glass.
3. Remove the 10 screws that fasten the top cover to the
rest of the firebox. There are: two (2) screws on each
side along the top edge; four (4) screws on the back
along the top edge, and two (2) screws on the top of the
fireplace (see Figure 8).
4. Flip the top panel over and rest it on the top of the
fireplace, across the rear half of the unit.
CAUTION: Use caution when flipping top panel over as
there are components attached to the top panel which are
wired to the internal cavity of the fireplace.
5. Referring to Figure 8, remove the three (3) Philips
screws on each side of the fireplace to release the Baffle
Figure 9
Underside of Baffle and
Switch Mount Bracket
Retainer Clips (one per side)
8
Top Cover
Baffle and Switch
Mount Bracket
On/Off
Switch