Installing The Tray 1 Media Support - Konica Minolta magicolor 2300 DL Installation Manual

Installing the Tray 1 Media Support

Remove the media support from its
plastic shipping bag, and then attach
it to Tray 1.
Insert the three tabs $ on the media
support into the three holes in Tray 1, and
then lower the two tabs % into their
corresponding holes below Tray 1.
Loading Tray 1 (Multipurpose Tray)
The multipurpose tray is used for all supported media types, including
envelopes, labels, Japanese-sized postcards, thick stock, and
transparencies.
Check www.minolta-qms.com/support (click on Answer Base) for currently
approved media. To order approved media, go to www.q-shop.com. For
information about loading different types of media, refer to "Using Media" in
the User's Guide.
Attention
Do not mix media types/sizes in the media trays.
1
Adjust the media guides to fit the size of
media that you are loading.
Squeeze the front media guide and open
the media guides.
2
Fan a stack of approximately 200 sheets
of paper.
8
$ $ $ $
% % % %
Setting up Your Printer