Fuse Replacement; Lamp Replacement - Elation Protron Color User Instructions

Protron Color™
Halogen Lamp Warning! This fixture is fitted with
halogen lamps which are highly susceptible to dam-
age if improperly handled. Never touch the lamps
with your bare fingers as the oil from your hands will
shorten lamp life. Also, never move the fixture until
the lamps have had ample time to cool. Remember,
lamps are not covered under warranty conditions.
Warning! Allow the lamp to discharge all current. Allow the
unit 24hrs. to discharge before changeing the lamp. Stored
current can cause a very severe shock.
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized Elation Professional
technician. Replace with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning:
If after you have replaced the lamp or fuse and you contin-
ue to blow either one, STOP using the unit. Contact customer support
for further instructions, you may have to return the unit for servicing.
Continuing to use the unit may cause serious damage.

Fuse Replacement:

Disconnect the unit's main power supply.
Insert a standard flat head screw driver in to the fuse holder hous-
ing (located on the rear of the unit). Turn the screwdriver in a coun-
ter-clockwise direction to remove the fuse holder. Remove the old
fuse and discard it, replace the fuse with the same type. Insert the
fuse holder back into it's housing and turn in a clockwise direction to
secure the holder in place.

Lamp Replacement:

Caution! Never open the unit when in use.
Always disconnect the main power and allow the fixture ample time
to cool before attempting to replace the lamp. Lamp replacement has
been made simple by incorporating a remove tray that is retained by a
single thumb screws. Again, please remember to always replace with
the exact same type lamp.
1. Be sure to follow the proper procedures when handling halogen
lamps. Never touch the new lamp with your bare fingers.
2. Unscrew the two thumb screws located on the glass cover in the
top corners of the unit.
3. Loosen the small phillips screw located to the right of the reflector
Elation Professional www.elationlighting.com - Protron Color™ Instruction Manual Page 12
© ® -
Lamp Replacement
®
Protron Color™
(diagram 1).
4. Gently rotate the reflector by hand so that the back of the reflec-
tor is now in the front (diagram 2 & 3).
5. Located at the back of the reflector is a white ceramic wire con-
nection block (diagram 4).
3. The ceramic block has six wires connected to it, three on each
side. The three wires on the left side are the lamp wires, they are
secured by a flat head screw.
4. NOTICE: When you disconnect the lamp wires to replace the
lamp, you will have to remember which wire went where. They
must be reconnected the same way.
4. Replace the lamp with an exact match. Connect the three wires to
the ceramic block as they were when you disconnected them.
5. Reassemble in reverse order.
Diagram 1
Diagram 3
Elation Professional www.elationlighting.com - Protron Color™ Instruction Manual Page 13
© ® -
Lamp Replacement
Diagram 2
Diagram 4