Table of Contents
Advertisement
INSTALLATION CHECK OFF LIST
This Slide Gate operator is installed for use in a Class _____ installation.
Each item on this installation check off list should be verified by the installer.
______ Two warning signs securely installed on each side of gate panel (required).
______ 1 or 2 safety photo beams installed, one across each side of gate opening (required).
______ 1 or 2 stop photo beams installed on each side of fixed gate panel (required).
______ Customer advised that gate in for vehicular traffic only (required).
______ A separate pedestrian entry and/or exit is provided (required).
______ Contact edges installed and functional at all hazard or pinch points.
______ Safety guards installed covering all cantilever wheels (required).
______ All controls located far out of reach of gate, fixed panel and operator (required).
______ This class operator is approved for the application of the operator (1, 2, 3 or 4) (required).
______ A sphere with a 2-1/4" diameter cannot be pushed through the gate or fixed panel.
______ A safety screen/mesh is installed with a minimum height of 4' from ground.
______ Controls intended to reset gate after obstructed installed in line of sight (required).
______ Hard wired contact sensors located and wired to avoid any mechanical damage.
______ Customer instructed and is clear on proper use of gate operator (required).
______ Customer instructed on proper use of all control devices used with operator.
______ Safety instructions were reviewed and left with customer (required).
______ Installer offered a preventative service/maintenance contract.
______ A photo of completed installation taken from front and back of gate and dated.
______ Gate conforms to the recommended ASTM F 2200-02 requirements.
Customer's Signature
Installer's Signature
Customer and installer should retain a copy of this check off list for their records.
4
Date
Date
Advertisement
Table of Contents
