Sharp ER-A520 Knowledge Book page 69

Quick Steps – Scale
To quickly setup the ER-A520/ER-A530 to interface with a Scale, please refer to the outlined
procedures below:
No. Description
Step–1 Connect the Scale
Step–2 SRV Job#903-B, C, D
Step–3 SRV Job#906-D
Step–4 SRV Job#918
Step-5 SRV Job#950
Step-6 PGM Job #2690
Step-7 Program Reset
PGM Job #2110
Step-8 -and/or-
PGM Job#2210
Specifications subject to change without notice: Revision date 10/07
Comments/Procedure
CH–1 or CH–2
903 [.] [@] x030
(For 3 Decimal Places) or
903 [.] [@] x020
(For 2 Decimal Places)
906 [.] [@] xxx1
(For Fractional Entries)
918 [.] [@] x0xx
(For Non-Scale Fractional Entries) or
918 [.] [@] x1xx
(For Disallowing Non-Scale Fractional Entries)
•
Place the [SCALE] Key (Function #107) on the keyboard
•
Place the [OPEN TARE] Key (Function #108) on the keyboard
2690 [.] [@] 1
or
2690 [.] [@] 1
Note: Must match the physical connection
•
Place the SRV-Key counter-clockwise to 6 o'clock position
(SRV' position)
•
Count 5 seconds
•
Turn SRV-Key clockwise to 7o'clock position (SRV position)
•
Verify"***PROGRAM RESET has printed on the journal-side
tape.
2110 [.] [@] (Dept. No.)
–and/or-
2210 [.] [@] (Dept. No.)
Y = Tare Table No. (1–9)
Z = Scale Comp. /Enabled/Inhibited = 2/1/0
PERIPHERALS
[CA/AT]
[CA/AT]
[CA/AT]
[CA/AT]
[CA/AT]
@ 0010 [SBTL] [CA/AT] for CH–1)
@ 0020 [SBTL] [CA/AT] for CH–2)
@ xyzxxx [SBTL]
@ xyz [SBTL]
[CA/AT]
[CA/AT]
Page 63 of 266