Customize Announcement Only Message; Base Ringer; Toll Saver - VTech Cordless Telephone User Manual

Answering system operation
/
Press PLAY/STOP
•
Customize the announcement only message
1 Press SETUP four times, the system announces "Announcement only. Record no messages. To
change the setting, press CHANGE "
2 Press CHANGE until the system announces "On "
3 Press SETUP three times, the system announces "Announcement. Press PLAY or press RECORD.
To continue, press SETUP"
4 Press REC/MEMO The system announces, "Record after the tone. Press STOP when you are
done" Speak toward the MIC on the base to record an announcement for up to 90 seconds
5 The elapsed time (in seconds) will be shown in the message window as you record
6 Press PLAY/STOP /
message then save it

Base ringer

1 Press SETUP five times, the system announces "Base ringer. To change the setting, press
CHANGE "
2 Press CHANGE
3 Press CHANGE again until the desired base ringer sounds
4 Press SETUP to save your selection and advance to the next setup option, or press PLAY/STOP
/
to save and exit

Toll saver

This function sets the number of rings before the answering system picks up the call With the toll
saver setting activated, the answering system alerts you whether there are new messages when
calling remotely from a touch tone phone If there are new messages on the answering system, the
system picks up the call after two rings When retrieving messages from a location where long distance
to save and exit
when you've finished recording. The system will play back your recorded
www vtechphones com 37