Advertisement
ELED Fresnel 150
LED Display:
The LED display will shut off after 15 seconds of inactivity. To make the
display reappear press and hold any button for at least 6 seconds.
Operating Modes:
Master-Slave Operation:
This function will allows you to link units together to run in a Master-
Slave mode. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units built-in programs.
Any unit can act as a Master or as a Slave however, only one unit can be
programmed to act as the "Master."
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit.
Use standard XLR cables to link your units together. Remember that
the Male XLR connector is the input and the Female XLR connector
is the ouput. The first unit in the chain (master) will use the female
XLR connector only. The last unit in the chain will use the male XLR
connector only.
2. Set the "Master" unit to your desired mode of operation.
3. For the "Slave" unit(s), press the MODE button until "XXX3" is dis-
played.
4. Connect the "Slave" unit or units and they will automatically start to
follow the "Master."
Manual Dimmer:
1. Plug the fixture in and press the MODE button until "XXX4" is dis-
played.
2. Use the UP and DOWN buttons to adjust the LED intensity.
This onboard control mode is regulated by the output setting.
Output Setting:
The Output Setting will set the output wattage level for manual control
and DMX dimming output.
1. Plug the fixture in and press the MODE button until "XXX5" is dis-
played. Either "1005" (100W) or "1505" (150W) will be displayed.
2. To change the setting press and hold the UP button for at least 6
seconds to change to 150W output, or press and hold the DOWN
button to change to 100W output.
Elation Professional - www.elationlighting.com - ELED Fresnel 150 Instruction Manual Page 7
Operating Instructions
ELED Fresnel 150
DMX Mode:
Operating through a DMX controller gives the user the freedom to create
their own programs tailored to their own individual needs. This function
also allows you to use your fixtures as spot lights. The ELED Fresnel 150
has 3 DMX modes: 1 Channel mode, 2 Channel mode - mode 1, and 2
Channel mode - mode 2. See page 9 for each modes' DMX traits.
1. This function will allow you to control each individual fixture's traits
with a standard DMX 512 controller such as the Elation® Show
Designer™ or the Elation® DMX Operator™.
2. To run your fixture in DMX mode, plug in the fixture via the XLR con-
nections to any standard DMX controller. Select your desired DMX
mode, and then press the UP or DOWN buttons to adjust the DMX
address. XXX = DMX Address
3. To run the 1 Channel Mode, press the MODE button until "XXX1"
is displayed. This is the DMX addressing for the 1 Channel DMX
Mode.
4. To run the 2 Channel Mode - Mode 1, press the MODE button
until "XXX2" is displayed. This is the DMX addressing for the 2
Channel DMX Mode - Mode 1.
5. To run the 2 Channel Mode - Mode 2, press the MODE button
until "XXX3" is displayed. This is the DMX addressing for the 2
Channel DMX Mode - Mode 2.
6. Please see page 9 for DMX values and traits
Elation Professional - www.elationlighting.com - ELED Fresnel 150 Instruction Manual Page 8
Operating Instructions
Advertisement
