Extruder & Evaporator
The extruding head bushing is replacable. It is a special bushing that contains no lead, and needs to be
pressed into the shaft. The thrust bearings will become worn and should be replaced annually or as
needed.
Auger Nut
The seal between the transmission and the evaporator should be replaced when necessary.
NOTE: Instructor to pain to manual reset overload location.
© 2003, IMI Cornelius Inc.
Nylon & Delrin thrust
bearings
FIGURE 4
FIGURE 5
Cornelius Ice Makers Training Manual
Extruding head
Extruding
head bushing
Evaporator
Seal
Transmission
- 9 -
Auger
Publication Number: TP00967