Operating The Horse Car And Corral - Lionel Operating Horse Car and Corral Owner's Manual

Operating the Horse Car and Corral

F
ollow these steps as you load and unload the Horse Car.
1. Position the car in front of the corral so that the car doors line up with the corral ramps.
2. Line up the horse figures in the corral passage so that they are facing in the direction of
the arrows. The gate heading to the drinking corral in the center of the corral should be
closed. See Figure 5 on page 8.
3. Open or close the center door on the side opposite of the corral doors to determine whether
the horses will travel all the way through the car.
• If the center door on the side opposite of the corral doors is closed, the livestock will
travel through the car, entering one door and exiting the other.
• If the center door on the side opposite of the corral doors is open, the livestock will
remain inside the car.
4. Press the activation button connected in the previous section to start the action. The corral
doors will drop down, allowing the horse figures to enter or exit the car. Regulate the speed
of the horses by adjusting the voltage or by turning the adjustment screw centered on the
bottom of the corral. See Figure 6.
Figure 6. Adjustment screw location

Adjustment
screw