Wiring Your Corral And Otc Contactor - Lionel Operating Horse Car and Corral Owner's Manual

Wiring your corral and OTC Contactor

Y
our Horse Car and Corral will operate best at 11-14 volts (AC). You will need to adjust
the voltage to obtain the optimum operation. Connect the corral and contactor to the
transformer terminals that supply power to the track. Refer to Figure 5 as you make these
connections.
The wires are attached to spring clip terminals on the corral and the contactor. To make
these connections, simply press down the spring clip and insert the bare end of the wire into
the exposed loop. Release the clip, and gently tug on the wire to be sure that you have a good
connection.
Gate
Figure 5. Power connections
Contactor
Switch
8
POWER
SUPPLY