JRC J-NAV 500 Instruction Manual page 73

GPS Navigator J-NAV500
Operation messages
Message
EVENT FULL
WPT FULL
NO WAYPOINT No waypoint has been registered.
ROUTE FULL
NO ROUTE
NOW USING,
IN ROUTE,
DEST PT
ARE YOU SURE?
ENT
CALCULATING The program is calculating distance or position of waypoint or route plan.
DOWNLOADING The unit is downloading data from external equipment. Please wait.
UPLOADING
SIM
WPT NO DEST
72
Too many events (waypoints) registered. This message is displayed when an
attempt is made registered a new event.
Delete old data before making new registration.
Too many waypoints registered. Delete old data before making new registra-
tion.
This message is displayed when an attempt is made to set a waypoint by enter-
ing positions, bearings or distance.
Register a waypoint.
Too many routes registered. Delete old data before making new registration.
No route has been registered.
Register a route.
A registered waypoint number has been specified in the registration of an event.
Register the event in a free waypoint number.
Confirmation message asking if a waypoint or route plan should be deleted.
Press to delete. To cancel deletion, press
Please wait.
The unit is uploading data to external equipment. Please wait.
The simulator mode is on. To exit simulator mode, turn it off.
No waypoint was set in a route plan or in direct route.
Description
.