Storing Waypoints - JRC J-NAV 500 Instruction Manual

GPS Navigator J-NAV500

4.17.2 Storing waypoints

1. Storing by LAT/LON (When the [L/L] is selected.)
Use the following procedure to enter waypoint by latitude and longitude.
in the [WAYPOINT] display mode. This displays the [WAYPOINT MENU] .
(1) Press
(2) Press to select [ENTER NEW WPT BY L/L] and press
can be entered is displayed. (For the example 001 has been registered.)
Display example
[First Display]
[WAYPOINT
MENU]
(3) Select waypoint number and press
(4) Enter the name of the waypoint in up to 8 characters.
The alphabet (26 characters), numbers (0 to 9), symbols (6) and spaces can be used for name
entries.
Symbol: (
Example: Fish 3
• Turn
•Turn
•Enter up to 8 characters using this procedure.
Since the first character of a waypoint name is displayed as a symbol of the waypoint in [PLOT]
display mode. It is a good idea to select a symbol or alphabetic character for the first letter.
(5) Set latitude and longitude in stated order.
N XX
S
When the entry has been made, the message "CALCULATING" is displayed indicating that the
bearing and distance from current position is being calculated. The calculation result is displayed
at the bottom of the screen.
50
[Display showing made entries]
)
to select symbol [ ] and press
to select space and press
XX. XXX' W
E
[Bearing, distance calculation results]
. If the displayed number is the right one, just press
.
.
XX XX. XXX'
. The lowest number that
[WAYPOINT
MENU]