GPS Navigator J-NAV500
4.2 Turning the unit on/off
•
Press
to turn on the unit.
•
Press
and
Display changes when the unit is turned on
When the unit is turned on, the displays are shown in the order given below: When position fixing is
completed, the [POSITION] display is shown.
[Version]
•
Position fixing the first time the navigator is used or after a master reset takes about 20
minutes. (Subsequent position fixing takes about 1 minute.) To shorten this time, perform
the operation described in Section 4.19.2, Initializing GPS/DGPS receiver.
•
For information on data error display, see the message list in Appendix A .
Master reset
This navigator is equipped with the following reset functions. For example, if the internal battery or the
ROM IC is replaced, a master reset would have to be performed.
When resetting the navigator, perform Initializing GPS/DGPS receiver as described in section 4.19.2
when correcting for local time.
1.
Soft reset
This reset clears all data except registered waypoints and route plans.
•
Key operated soft reset
Press the
•
Menu selected soft reset
See Section 4.22, "To perform a master reset."
2.
Hard reset
This reset clears all data including registered waypoints and route plans.
•
Menu selected hard reset
See Section 4.22, "To perform a master reset."
24
simultaneously to turn off the unit.
[Self-test result]
key while holding down the
GPS status information
key.
After position fixing