JRC J-NAV 500 Instruction Manual page 10

Automatic sequencing mode
Manual sequencing mode
Default value
NMEA0183
Master reset
Initialization
Function that automatically steps from one waypoint to the next
when the arrival perpendicular point has been detected.
The unit sounds the arrival alarm and the operator will manually
press key to step to next leg in the route plan when it is safe to
do so.
Factory set value
National Marine Electrical Association 0183. Association es-
tablishing international standards for communications between
navigational equipment and the standard established by NMEA.
A function for clearing all settings and returning to the factory
set values (default values). Two types of master resets are pro-
vided. A soft reset clears all data except for waypoint and route
plan data. A hard reset clears all data.
It takes up to 20 minutes to GPS position fixing when it is used
for the first time or after a master reset has been performed.
This time can be reduced by entering initialization values such
as estimate position, time and antenna height.
GPS Navigator J-NAV500
9